间隙 - 关于间隙的双语例句 - 间隙造句 - 语文书

为您找到36个与“间隙”相关的双语例句：

The sun appeared through a rift in the clouds.
太阳从云层间隙中冒出来。
We had a talk between takes.
在拍摄镜头的间隙, 我们谈了一次话。
Secondary interstices develop after the rock is formed.
在岩石形成以后再发展次生间隙.
In the larger interstices, this fluid has the ability to limit circulation.
在较大的间隙内, 此液体有限制流通的性能.
It is because of the big clearance between the brake facings?
是不是因为刹车片之间的间隙太大了?
Please leave a space between the lines for the necessary corrections.
在行与行之间要留出间隙,以便作必要的修改.
The bridge and the top of the bus was only ten clearances.
桥与公共汽车车顶之间的间隙只有十厘米.
Theatre lobbies were filled with a vociferous crowd during the intermission.
剧场大厅放映间隙,人群中发出喧闹的嘈杂声.
B , Interval between top sheet and drapes covered by sterile pillowcases.
上单与底单间隙用无菌枕套覆盖.
B, Interval between top sheet and foundation drapes covered by sterile pillowcases.
B上单与底单间隙用无菌枕套覆盖.
Up to then, they'd merrily bashed out albums in between tours.
那时，他们已经利用巡演的间隙轻松炮制了多张专辑。
Objective To evaluate the relationships between retromammary space and complications augmentation mammaplasty with injection.
目的探讨乳腺后间隙与注射式隆乳并发症的关系.
Recheck clearance on all valves again after locknut is tightened.
防松螺母拧紧后,再对所有气门的间隙重新检查一次.
Recheck clearance again after tightening locknut . Readjust clearance as necessary.
拧紧防松螺母后,再一次检查间隙,视需要重新调节间隙.
The energy band gaps of sputtered Cr 03 are approximately 1 . leV ( AD ) and 1 . 4 eV ( HT ).
其中第三种溅射铬-氧薄膜(C_ rO3)的能带间隙约 1.leV ( A-D ) 和1.4eV ( H-T ).
This paper presents a 3 - D model for double - gap open cavity of S - band relativistic klystron amplifier.
建立了S波段相对论速调管放大器双间隙输出腔开放腔的3 维模型.
The ionized particles then flow past a set of closely spaced metal plates.
然后,被离子化的粒子流过一组间隙很小的金属板.
Please note there is 1 - 1.5 mm interspace of each piece to adjust.
注意每块间预留1-1.5毫米间隙以便微调作品.
The interelectrode gap could be controlled only within several to several ten microns using this system.
该系统能够将加工间隙控制到几微米到几十微米的范围内.
Firstly, the relation between 6 - dimision forces received by cathode from electrolyte and interelectrode gap is researched.
首先研究六维力与加工间隙之间的关系.